Powering On The Hafm Appliance - HP StorageWorks HA-Fabric Manager Installation Manual

3. As shown in
rear of the appliance and to a facility telephone connection.

Powering On the HAFM Appliance

To power on the HAFM appliance:
1. As shown in
power source or rack power strip that provides single-phase, 90 to 264 VAC current.
When the power cord is connected, the appliance powers on and performs power-on
self-tests (POSTs). During POSTs:
a.
b.
c.
d.
32
Figure 2-7, connect the phone cord to the left RJ-11 adapter (LINE) at the
Warning
Use the supplied power cords. Ensure the facility power receptacle is the correct type,
supplies the required voltage, and is properly grounded.
Figure 2-7, connect the AC power cord to the appliance and to a facility
The green liquid crystal display (LCD) panel illuminates.
The green hard disk drive (HDD) LED blinks momentarily, and processor speed and
random-access memory information display momentarily at the LCD panel.
After a few seconds, the LCD panel displays the following message pertaining to
boot sequence selection
Figure 2.8. LCD Panel During Boot Sequence
Ignore the message. After ten seconds, the appliance performs the boot sequence
from the basic input/output system (BIOS). During the boot sequence, the appliance
performs additional POSTs and displays the following operational information at
the LCD panel:
• Host name.
• System date and time.
• LAN 1 and LAN 2 Internet Protocol (IP) addresses.
• Rotational speed status on multiple appliance fans.
• Central Processing Unit (CPU) Temp
• Hard disk capacity
(Figure 2-8):
hp StorageWorks HA-Fabric Manager Appliance Installation
Chapter 2. Installation
Guide