Appliance Module Leds And Components - HP HPE Synergy 12000 Frame Setup And Installation Manual

Appliance module LEDs and components

Appliance module LEDs and components
Appliance module LEDs and components are the same for both an HPE Synergy Composer (1st gen) and an HPE Synergy Image
Streamer. The HPE Synergy Composer2 looks slightly different but has the same LED and components on the front panel.
The following figure shows an HPE Synergy Image Streamer on the left and an HPE Synergy Composer2 on the right:
Item Item Description Description
1 UID LED
2 Health LED
3 Activity LED
4 Power LED
Function Function
Solid blue — Illuminates to locate the appliance module.
Flashing blue — Indicates appliance module firmware update. Do not power off or remove
appliance module when the UID LED is flashing.
Indicates the health of the appliance module.
Solid green — Normal operation
Flashing amber — Warning
Flashing red — Critical error
The Health LED provides health status of the appliance module. If the Health LED indicates a
warning or a critical error, connect to the HPE Synergy Console to troubleshoot.
Indicates which appliance module is active.
Off — Indicates that the appliance module is the standby in a Highly Available configuration
or HPE OneView is in an error state.
Solid green — Indicates that the appliance module is active.
Flashing green — Indicates that the reset button has been pressed and held for greater than
10 seconds, which initiates a reimaging of the appliance module. The active LED does not
continue to flash green during the reimaging process.
Indicates power to the appliance module.
Off — No power. Verify that the appliance module is fully inserted into the frame link
module.
Flashing amber — The appliance module is initializing.
Solid amber — The appliance module is powered off.
Solid green — The appliance module is powered on.
Appliance module LEDs and components 31