Manually Configuring Private Lan Addresses Using Dhcp; Lcd Panel (Password Entry); Lcd Panel (Dhcp Selection); Lcd Panel (Auto Get Dns) - HP StorageWorks HA-Fabric Manager Installation Manual

Chapter 3. Configuration
You can configure the private LAN connection (LAN 2) using one of the following methods:
• Use Dynamic Host Control Protocol (DHCP) to assign the HAFM server IP address,
subnet mask, and default gateway IP address. You can either auto-detect or manually
select the DNS server IP address.
• Manually enter the HAFM server IP address, subnet mask, default gateway IP address, and
DNS server IP address.

Manually Configuring Private LAN Addresses Using DHCP

To configure TCP/IP network information for the private LAN connection (LAN 2):
1. At the LCD panel, press ENTER. The Welcome!! or operational information message
changes to the following
2. Using the
to move the cursor left, and the
password (9999), then press ENTER. The LAN 1 Setting?? message displays
at the LCD panel.
3. Press the
4. Press ENTER and the following message displays
DHCP.
5. Use the arrow keys as described in step 2 and select YES to use DHCP, then press
ENTER. The following message displays
hp StorageWorks HA-Fabric Manager Appliance Installation
Guide
(Figure 3-15):
Figure 3.15. LCD Panel (Password Entry)
button to increment a digit, the
button to move the cursor right, input the default
button until the LAN 2 Setting?? message displays at the LCD panel.
Figure 3.16. LCD Panel (DHCP selection)
Figure 3.17. LCD Panel (Auto Get DNS)
button to decrement a digit, the
(Figure 3-16) to allow the selection of
(Figure 3-17):
button
41