Configuring Private Lan Addresses; Lcd Panel (Input Gateway); Lcd Panel (Input Dns); Lcd Panel (Save Change) - HP StorageWorks HA-Fabric Manager Installation Manual

5. Use the arrow keys as described in step 2 to input a new subnet mask, then press ENTER.
The following message displays
(each three decimal digits) are the same as the IP address entered in step 5, and the last
octet is set to decimal 254 (or the default gateway IP address of 0.0.0.0 is displayed).
6. Use the arrow keys as described in step 2 to input a new gateway IP address, then press
ENTER. The following message displays
IP address of 0.0.0.0.
7. Use the arrow keys as described in step 2 to enter the IP address for the DNS server, then
press ENTER. The following message displays
8. Use the up and down arrow keys as described in step 2 to select YES, then press ENTER.
If you saved the changes, a Wait a moment!! message displays at the LCD panel
and the LCD panel returns to the LAN 1 Setting?? message.
9. Press the up and down arrow keys until Return?? is displayed, then press ENTER.
The LCD panel returns to scrolling mode, which continually displays HAFM appliance
operational information.
10. Record the private LAN IP address and subnet mask for reference if the appliance hard
drive fails and must be restored.

Configuring Private LAN Addresses

Note
Before starting this procedure, ensure that the LAN 2 interface is physically connected to the LAN.
An LCD display of 0.0.0.0 indicates a physical LAN connection is not present.
40
(Figure
Figure 3.12. LCD Panel (Input Gateway)
Figure 3.13. LCD Panel (Input DNS)
Figure 3.14. LCD Panel (Save Change)
hp StorageWorks HA-Fabric Manager Appliance Installation
3-12) with an IP address whose first three octets
(Figure 3-13) with the default DNS server
(Figure 3-14):
Chapter 3. Configuration
Guide