Installing Slide Rails - HP StorageWorks HA-Fabric Manager Installation Manual

Chapter 2. Installation
a.
b.
c.

Installing Slide Rails

To attach the left and right slide rails to the HAFM appliance:
1. As shown in
(10) pan-head Phillips screws (M4 x 10 cm). Use five (5) screws per side. Ensure the
screws are securely tightened.
hp StorageWorks HA-Fabric Manager Appliance Installation
Guide
Figure 2.3. Bracket Installation
Slide the mounting bracket flanges between the bar nuts and rack-mounting
standards. Adjust the overall length of each bracket assembly if required.
To allow tolerance for appliance installation, tighten the three-hole bar nut screws
(bracket-to-rack mounting standard) so the brackets are stable, but can be moved
laterally.
Note
Ensure the bar nut screw washers to do not overlap the inside edges of the rack-mounting
standards and mounting brackets. Washer overlap may interfere with slide rail operation.
Using a #2 Phillips screwdriver, securely tighten the bar nut screws (two per bracket
assembly, four total) that connect the front and rear brackets.
Figure 2-4, attach the left and right slide rails to the appliance with ten
27