Detailed Description And Use Of Additional Services; Functional / Keypad Protocol; Hot Line (Hl) - Intracom netMod User Manual

Detailed Description and Use of Additional Services

1.

Functional / Keypad Protocol

If the ISDN exchange is using the FUNCTIONAL protocol to activate / deactivate the
supplementary services, you do not need to program anything. netMod initially supports
the FUNCTIONAL protocol.
If the ISDN exchange supports the KEYPAD protocol for the activation / deactivation of
supplementary services, then it has also to be activated in netMod.
•
To activate the KEYPAD protocol, press
•
To re-establish the FUNCTIONAL protocol, press
Alternatively, you can activate the KEYPAD protocol by writing on the register S100 the
value '1'. If the ISDN exchange supports only the KEYPAD protocol, the supplementary
services Three Party Conference and Malicious Call Identification are not supported.
The activation of KEYPAD protocol using the keypad commands is permanent. Any
change is saved in "user profile 0" which becomes the "active profile" after restarting the
system (hardware reset). The activation of KEYPAD protocol using S-Registers is not
permanent. In this case to permanently store these changes, the user has to follow the
process for permanent storage of S-Registers settings.
2.

Hot Line (HL)

If you have activated the HL service and you hook off the handset of your telephone
device, then an inspection of 10 seconds starts. After 10 seconds, a call is made to a
preselected subscriber number. If the subscriber calls another subscriber number before
the end of 10 seconds, the HL service is cancelled.
•
To activate the HL service press
•
To deactivate the HL service press
User's Manual of netMod Network Termination Unit
**11#
**10#
*53*Number#
#53#
33