Call Hold And Enquiry Call (Ch); Three Party Conference (3Pty) - Intracom netMod User Manual

User's Manual of netMod Network Termination Unit
3.

Call Hold and Enquiry Call (CH)

The subscriber can have an active call on line and make a second call from the same
analogue port.
The key combinations are listed below:
FLASH
• The key
• After the dial tone, the enquiry call can take place by dialling the called subscriber
number and waiting for an answer.
Then the following keys can be pressed:
FLASH 2
• The keys
or
FLASH 1
• The keys
or
FLASH 0
• The keys
4.

Three Party Conference (3PTY)

When the subscriber has an active call on line and a second call on hold, then by pressing:
FLASH 3
• The keys
held call.
If the subscriber has a three party conference established then by pressing:
FLASH 2
• The keys
on line and a second call on hold.
to place the active call on hold and wait for the dial tone.
to switch between the two calls
to release the active call and retrieve the call on hold
to clear the call on hold.
establish a three party conference for the active call and the
split up the three party conference. There is again an active call
24