Default Button; Figure 2.15 Securing A Terminal Block To A Receptor - Advantech EKI-1222R-CE User Manual

6. Align the terminal block over the terminal block receptor on the modbus router.
7. Insert the terminal block and press it in until it is flush with the terminal block
receptor.
8. Tighten the screws on the terminal block to secure it to the terminal block
receptor.
If there is no gap between the terminal block and the terminal receptor, the
terminal block is seated correctly.

Figure 2.15 Securing a Terminal Block to a Receptor

2.7

Default Button

Reset configuration to factory default:
Press and hold the Default button for 10 seconds.
System reboot:
Press the Default button.
Note! Do NOT power off the modbus router when loading default settings.
22 EKI-122xR-CE Series User Manual