Table of Contents
Advertisement
Once the wall mounting plates are secure on the device, you will need to attach the
wall screws (x4).
7.
Locate the installation site and place the modbus router against the wall, making
sure it is the final installation location.
8.
Use the wall mount plates as a guide to mark the locations of the screw holes.
9.
Drill four holes over the four marked locations on the wall, keeping in mind that
the holes must accommodate wall sinks in addition to the screws.
To mount the wall plate, use screws of the size shown in the following
illustration.
Figure 2.5 Wall Mounting Screw Dimensions
Note!
Make sure you use the recommended screw length for your particular
application. The screws need to penetrate properly for the rated weight
rating.
10.
Align the wall mount plate over the screws on the wall.
11.
Install the wall mount plate on the screws and slide it forward to lock in place,
see the following figure.
12.
Once the device is installed on the wall, tighten the screws to secure the device.
8.0 mm
4.0 mm
2
1
2
Figure 2.6 Wall Mount Installation
16
EKI-122xR-CE Series User Manual
Advertisement
Table of Contents
