1.9 DIN Rail Mounting
The DIN rail clips are not included as standard accessories with the router. However, they can
be ordered using the order code BB-DIN-ICR32 (two pieces for one router).
You can attach two DIN rail clips to the router for mounting it onto a DIN rail that complies
with the 60715 standards. The default position of the clips is depicted in Figure 9. If necessary,
the clips can also be rotated vertically.
When attaching the clips, tighten the screws with a maximum torque of 0.4 Nm.
Figure 9: Default Position of the DIN Rail Clips
To remove the router from the DIN rail, lightly push down on the router to disengage the
bottom part of the DIN rail clip from the rail. Then, pivot the bottom part of the router away
from the DIN rail, as demonstrated in Figure 10.
Figure 10: Removing Router from the DIN Rail
13
ICR-4461