Barco UDX Series User Manual page 159

Image 10-8
5. If required by the chosen wireless network, fill in the username and password and confirm.
Tip: If you already connected to this network in the past using this projector, the software will
remember the username and password, ensuring you do not have to fill this in again.
6. Press Connect to connect to the selected network.
An automatic IP address is assigned.
When connected to this network, it is indicated in the upper right corner of the menu with the term "connected".
How to manually set up the IP address
1. In the main menu, select System Settings → Communication → WiFi.
Image 10-9: Communication menu, WiFi
The WiFi menu is displayed.
Image 10-10: WiFi menu
2. Disable Automatic. Put the lower switch to the left. The switch becomes gray and the label will read "Manual".
3. Use the ▲ or ▼ key to select Address and press OK button to activate the input box.
4. Use the ▲ or ▼ key to change the selected character.
Use the ◄ or ► key to select another character.
GUI – System Settings
R5906112 /09 UDX series 159