To Wire Inputs And Outputs - Carrier UC Open Installation And Startup Manual

To wire inputs and outputs

1
Verify that the UC Open's power and communications connections work properly.
2
Pull the screw terminal connector from the controller's power terminals labeled Gnd and Hot.
3
Connect the input wiring to the screw terminals on the UC Open.
NOTES
Connect the shield wire to the GND terminal with the ground wire.
○
IN-5 and IN-6 share the GND terminal above IN-5.
○
UC Open
Installation and Start-up Guide
9
Installing the UC Open
CARRIER CORPORATION ©2019
All rights reserved