Assembly - Husqvarna 565 Workshop Manual

Ignition system

11.3 Assembly

1. Fit the flywheel on the shaft. Turn it gently until the
key on the flywheel mates with the recess in the
shaft.
2. Fit the flywheel washer and nut. See figure 7.
3. Fit the two pawls on the flywheel. Make sure that
they can move freely when fitted. See figure 5.
4. Remove the piston stop and reattach the spark plug.
See figure 5.
5. Fit the ignition module (B) without tightening the two
M5 screws. See figure 8.
6. Turn the flywheel so that its magnet (G) comes
opposite from the ignition module (B). See figure 8.
Fig. 5
Fig. 6
24 - English
7. Insert the feeler gauge Air Gap Tool (0.3 mm)
between the ignition module and the flywheel
magnet. The clearance only applies to the two lower
pegs on the ignition module. See figure 8.
8. Push the ignition module against the flywheel and
tighten the screws (D). See figure 8.
9. Fit the lead with cable and press the ignition cable
in place and attach the spark plug cap to the spark
plug.
10. Connect the cable connected to the contact on the
Autotune unit. See figure 6.
11. Fit the remaining parts on the chainsaw. See
respective chapters.
Fig. 7
B
0,3mm
Air gap tool
D
Fig. 8
25Nm
G