Assembly - Husqvarna 565 Workshop Manual

Chain brake

5.3 Assembly

1. Fit the hand guard with the sleeves on the chainsaw.
Attach the hand guard on the starter side (B). See
figure 8. Make sure that the sockets on the hand
guard are intact.
2. Grease the moving parts of the toggle joint (D) and
fit the unit on the chainsaw. See figure 6.
3. Attach the screw to the hand guard on the clutch
side (A). Make sure that the sleeve in the socket is
in place. See figure 8.
4. Compress the spring using a conical screwdriver
6.5 mm wide and press it down with your thumb.
See figure 7. Hold the spring down with two fingers.
WARNING! Ensure that the spring does
not fly out and cause personal injury.
5. Grease and fit the lever (A). See figure 6.
6. Grease and fit the retaining bush (B) with spring (C).
See figure 6.
7. Make sure that the brake band is correctly positioned
in the recess in the crankcase. See figure 9.
8. Fit the chain guide-plate with screw (A). See figure 1.
9. Pull back the hand guard so that the chain brake
is disengaged.
10. Fit the cover over the chain brake mechanism.
Three screws (B). See figure 1. Fit the middle screw
last and hold two fingers steadily on the cover until
the cover is fully attached.
11. Grease the needle bearing. Fit the clutch drum (E)
with needle bearing (D) and chain drive sprocket
(C). See figure 2.
12. Fit the washer (B) and locking ring (A). See figure 2.
13. Fit the cylinder cover, chain and bar.
14 - English
D
Fig. 6
Fig. 7
A B
Fig. 8
Fig. 9
A
C B
6.5mm