Tank Unit; Dismantling; Replacing The Fuel Hose - Husqvarna 565 Workshop Manual

WARNING! The fuel used in the chainsaw
has the following hazardous properties:
1. The fluid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.

15.1 Dismantling

1. Drain the fuel from the tank.
2. Remove the cylinder cover, chain and bar.
3. Remove the air filter.
4. Unhook the throttle cable (A) from the carburettor
and the throttle cable casing. See figure 1.
5. Remove the fuel hose (B), tankvent hose (D) and the
return hose (C). See figure 1.
6. XPG: Remove the cover on the front handle and
dismantle the three cables. See chapter Replacing
the generator.
7. Remove the bolts (D, F and G) and dismantle the
front handle. See figure 2.
8. Remove the vibration damping units (E). See figure 2.
9. XPG: Remove the grounding cable.
10. Remove the air purge and pull the fuel hose,
tankvent hose, return hose and throttle cable out from
underneath the carburettor area base.
11. Carefully remove the tank unit.
CAUTION! Take care not to damage the
fuel hose, return hose, tankvent hose or
throttle cable.

15.2 Replacing the fuel hose

1. Use a pair of pliers with smooth jaws and pull out
the fuel hose from the fuel tank (H). Pull off the fuel
filter (I). See figure 3.
2. Fit the new fuel hose and fuel filter in the tank unit.
See figure 3.

15 Tank unit

Fig. 1
E
Fig. 2
Fig. 3
A
D
F
E
H
Tank unit
B
C
D
2 xG
I
English - 41