Seals; Bar Bolts - Husqvarna 565 Workshop Manual

18.4 Seals

1. To replace the seals on the crankshaft, remove the
following parts:
On the flywheel side:
• Starter.
• Flywheel.
• XPG: Generator.
On the clutch side:
• Chain and bar.
• Chain guide plate.
• Centrifugal clutch.
• Oil pump.
2. Use a screwdriver to pull the seal out. See figure 14.
3. Fit the new seal using Pressing tool (seals). See
figure 15.
CAUTION! Make sure that the seal is flat
against the bearing.
4. Fit the parts in accordance with step 1 above. See
respective chapter.

18.5 Bar bolts

1. Drain the chain oil.
2. Tap the old bar bolt from outside so that it drops in
the oil tank. See figure 16.
3. Remove the bolt from the oil tank.
4. Fix a piece of steel wire on the end of the new bolt,
and pull it through the oil tank and out through the
bolt hole in the crankcase. See figure 16.
5. Pull the steel wire so that the bolt enters its hole.
6. Pull out the bolt in its nut and shim between the
nut and crankcase. See figure 17.
7. Check that the square head of the bolt comes in its
recess in the crankcase. Where appropriate, turn the
bolt.
8. Refill with chain oil.
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Crankcase and crankshaft
English - 51