Cleaning And Inspection; Cleaning And Inspection Of The Air Channel - Husqvarna 565 Workshop Manual

5.2 Cleaning and inspection

Clean and inspect all parts. The thickness of the brake
band must nowhere be less than 0,8 mm. See figure 5.
5.2.1 Cleaning and inspection of the air
channel
This chainsaw is equipped with an air channel that
reached from the flywheel side to the clutch side.
NOTE! Cleaning and inspection of the air
channel can only be performed if the
chain-guide plate and the cover over the chain
brake mechanism is removed (see figure 1) on
the clutch side and the starter on the flywheel
side (see chapter Starter).
1. Do a visual check for dirt in the air channel.
2. Remove any dirt from the air channel by
pushing a Torx T27 or the like through the air
channel. Compressed air can also be used for this
purpose. See figure 6 and 7.
CAUTION! If the air channel gets clogged
there is a risk that the chainsaw gets
overheated.
Min. 0.8 mm
Fig. 5
Fig. 6
Fig. 7
Chain brake
English - 13