Introduction And Safety Regulations; General; Safety; Target Group - Husqvarna 565 Workshop Manual

1.1 General

This Workshop Manual provides a comprehensive
description of how to trouble shoot, repair and test the
chainsaw. A description of different safety measures
that should be taken during repair work is also given.

1.2 Safety

Note! The section dealing with safety should be
read and understood by all who carry out repair
and service work on the chainsaw.
Warning symbols can be found in this Workshop
Manual and on the chainsaw. See page 5. A new
warning symbol must be applied as soon as possible if
a warning symbol on the chainsaw has been damaged
or is missing to ensure the greatest possible safety
when using the chainsaw.

1.3 Target Group

When producing this Workshop Manual the assumption
has been made that personnel who use it have general
knowledge in the repair and service of small engines.
The Workshop Manual must be read and understood by
personnel who are to carry out repair work and service
on the chainsaw. The Manual is also suitable for use
when training new employees.

1.4 Modifications

Modifications will be successively introduced on the
chainsaw during production. When these modifications
affect servicing and/or spare parts, separate service
information will be sent out on each occasion. This
means that in time this Workshop manual will become
out of date. In order to prevent this, the Manual should
be read together with all service information issued
concerning the chainsaw in question.

1 Introduction and safety regulations

Introduction and safety regulations

1.5 Layout

This Workshop Manual can be used in two different
ways:
• For the repair of a particular system on the
chainsaw.
• Dismantling and Assembly of the entire chainsaw.
Repair of a particular system
When a particular system on the chainsaw is to be
repaired, proceed as follows:
1. Look up the page for the system in question.
2. Carry out the sections: Dismantling
Cleaning and inspection
Assembly
Dismantling and Assembly of the entire chainsaw
Proceed as follows when the entire chainsaw is to be
dismantled and assembled:
1. Look up the starter chapter and carry out the
instructions under the heading Dismantling.
2. Leaf forward in the book and carry out Dismantling
in the order given in the sections.
3. Go back to the Starter chapter and carry out the
instructions under Cleaning and inspection.
4. Leaf forward in the book and carry out Cleaning
and inspection in the order given in the sections.
5. Order or take out all requisite spare parts from the
stores.
6. Look up the Crankcase chapter and carry out the
instructions under Assembly.
7. Leaf forward in the book and carry out Assembly
in the order given in the sections.
To improve understanding some sections provide a
Description first of the actual unit. Some chapters also
conclude specific instructions that explain how to repair
or replace a certain component.

1.6 Numbering

Position references to components inside the figures
are designated A, and B, etc.
The figures are number 1, 2 etc.
The position references figure numbers restart in each
new section.
English - 3