Fitting The Carburettor On The Chainsaw - Husqvarna 565 Workshop Manual

Carburettor
14.8 Fitting the carburettor on the
chainsaw
NOTE! When replacing the carburettor, a firmware
download is required on the new unit and it has to
pass the test "autotest" in CST before use. See
instruction in CST. (Documents/Handheld/Auto-
Tune/User Guide).
1. Press the connector together and push it into place
in the holder. See figure 17.
2. Make sure the cabling is fitted to its mounting on the
intake flange. See figure 18.
3. Press the fuel hose (C) in place in the collar on the
intake bellows. See figure 19.
4. Hook on the throttle cable (D) in its mounting on the
intake bellows. See figure 19.
5. Make sure the lug on the carburettor hooks in place
on its mounting on the intake system. See figure 19.
CAUTION! Make sure that the fuel and
return hoses are not crushed.
38 - English
Fig 17
Fig 18
C
Fig 19
D