Muffler; Dismantling; Cleaning And Inspection; Assembly - Husqvarna 565 Workshop Manual

7.1 Dismantling

1. Remove the cylinder cover.
WARNING! Do not touch the muffler
until it has cooled. Risk of burn
injuries.
2. Remove the spark-arrester if one is fitted (one
screw). See figure 1.
3. Remove the four bolts. See figure 1.
4. Remove the gasket and cooling plate. See figure 1.

7.2 Cleaning and inspection

Clean all components and check the following:
1. That the spark-arrester is intact.
2. That the muffler and muffler mounting are not
cracked or in any way defect.
3. That the gasket is undamaged.
CAUTION! Replace the gasket if it is
damaged. The gasket has to be fitted
correctly against the muffler.

7.3 Assembly

1. Clean the contact surfaces to the gasket, cooling
plate and cylinder.
2. If the chainsaw is fitted with a spark-arrester, refit it.
See figure 1.
3. Fit the cooling plate, gasket and muffler to the
cylinder. See figure 1.
4. Finger-tighten the four screws and then screw all
screws fully. See figure 1.
NOTE! The two shorter screws are fitted in the
holes against the crankcase and the two
longer screws are fitted in the holes against
the cylinder.

7 Muffler

Fig. 1
Muffler
English - 17