WARNING! The fuel used in the chainsaw
has the following hazardous properties:
1. The fluid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
16.1 Dismantling
1. Dismantle the following parts:
• Chain and bar.
• Cylinder cover.
• Front handle.
2. Unscrew the screw in the vibration damping unit (D)
with a screwdriver. Unscrew the bolt attached to the
cylinder with Torx T27. Dismantle the
vibration damping unit on the front handle. See
figure 1.
3. Unscrew the screw in the vibration damping unit with
Torx T27 and the bolt attached to the tank unit with
Torx T27 to dismantle the front and the rear vibration
damping units (E). See figure 2.
NOTE! Unscrew the cylinder screw in the front
handle when dismantling the front and rear
vibration damping units. This makes it easier
to remove the vibration damping units from
the tank unit.
16.2 Cleaning and inspection
Clean and inspect all parts.
16.3 Assembly
1.
Replace any damaged or worn vibration damping
units.
2.
Fit the springs on the cylinder and tank with Torx
T27.
NOTE! Harder springs are available. Should
only be used together with longer guide bars.
See IPL for part number.
3.
Assemble the following parts:
• Front handle.
• Cylinder cover.
• Chain and bar.
16 Anti-vibration system
Fig. 1
D
F
E
Fig. 2
Anti-vibration system
D
2 xG
E
English - 43