Throttle Lock, Throttle Trigger And Return Spring - Removal - Husqvarna 140 Workshop Manual

Safety equipment
6.9 Throttle lock, throttle trigger and
return spring – removal
1
Loosen the throttle actuator rod on the carburettor,
the fuel hose and the suction hose to the fuel pump.
2
Dismantle the tank unit from the engine unit by
loosening the screws A (see figure 17)
3
Dismantle the handle insert (B) by loosening the
screw C on the handle (see figure 18).
4
Press out the throttle control pin (D) with the help
of a punch (see figure 19).
5
Loosen the throttle lock as illustrated with the help
of a screwdriver or the like. Then dismantle from
the shaft in the handle (see figure 20).
6
Dismantle the throttle control (see figure 20).
7
Now loosen the spring.
22
– English
Fig 17
Fig 18
Fig 19
Fig 20
Fig 21