Wall Mount Bracket - Ganz ZT-PTS Series Instruction Manual

Installation
C. Wall Mount Bracket

1. WALL MOUNT BRACKET

2. SET ANCHOR BOLT (W5/6)
3. SCREW M4 x 16
C-1. When you install Camera on the wall, make 4 holes at the edge with Ø13 in
diameter and 37mm in depth and install 4 pieces of Anchor bolt in the Ø13
holes at the edge. (FIG.11)
• If you want to connect the cables from the inside of the wall, also ake a hole
for the cables with about Ø30~50 in diameter in the center of 4 edges.
• In order to avoid the impact of the Camera and Bracket when moving, set
and drill in the long side as length and the short side as height.
• Check also if the long side of the Bracket sets as length and the short side
of the Bracket sets as height.
C-2. Connect the Camera to Wall Mount Bracket with 4 pieces of M4 x 16 screws
and Spring Washer. (FIG.12)
(M4 x 16 - 4EA)
CONTENTS
1EA 4. SPRING WASHER Ø4
4EA 5. WRENCH (3mm)
5EA 6. MANUAL
012
Installation
ZT-PTS SERIES
C-3. Connect the Safety wire of the Camera to the Bracket. In order to avoid
getting entangled in the Camera, fasten the Safety wire to the bracket with
Cable tie. (FIG.13)
5EA
1EA
C-4. When you want to connect the cables from the inside of wall, pass the cables
through the wall. When you want to connect the cables from the outside of
wall, remove the hole cap from the side of the bracket and pass the cables
through the hole.
C-5. Install 4 pieces of Anchor bolt in the holes at the edge and tight enough
with Nuts. (FIG. 13)
C-6. Connect the cables referring to the page 8. (FIG.14)
ZT-PTS SERIES
013