Ceiling Mount Bracket - Ganz ZT-PTS Series Instruction Manual

Installation
A. Ceiling Mount Bracket

1. CEILING MOUNT BRACKET

2. SET ANCHOR BOLT (W5/9)
3. SCREW M4 x 16
A-1. When you install Camera on the ceiling, make 4 holes at the edge with Ø13
in diameter and 37mm in depth. If you want to connect the cables from the
inside of the ceiling, also make a ole for the cables with about Ø30~50 in
diameter in the center of 4 edges. (FIG.1)
A-2. Connect the Ceiling Mount Bracket to the Camera with 4 pieces of M4X16
screws and spring washer. (FIG.2)
A-3. Connect the Safety wire of the Camera to the Bracket. In order to avoid
getting entangled in the Camera, fasten the Safety wire to the bracket with
Cable tie. (FIG.3)
(M4 x 16 - 4EA)
CONTENTS
1EA 4. SPRING WASHER Ø4
4EA 5. WRENCH (3mm)
5EA 6. MANUAL
008
Installation
ZT-PTS SERIES
A-4. When you want to connect the cables from the inside of ceiling, pass the
cables through the ceiling. When you want to connect the cables from the
outside of ceiling, remove the hole cap from the side of the bracket and pass
the cables through the hole.
5EA
4EA
A-5. Install 4 pieces of Anchor bolt in the holes at the edge and tight enough
with Nuts. (FIG.4)
A-6. Connect the cables referring to the page 8. (FIG.5)
ZT-PTS SERIES
009