Pole Stand - Ganz ZT-PTS Series Instruction Manual

Installation
B. Pole Stand

1. POLE STAND

2. BOLT & NUT M10
3. FLAT WASHER
4. SPRING WASHER Ø10
B-1. When you install Camera on the pole, make 4 holes at edge with Ø13 in
diameter and 37mm in depth.
Make also a hole for the cables with about Ø30~50 in diameter in the
bottom center of the bracket. (FIG.6)
B-2. Pass the cables of the camera through the inside of Pole Stand and connect
the Camera to the Pole Stand with pieces of M4*16 screws. (FIG.7)
B-3. Connect the Safety Wire of the camera to the bracket.
In order to avoid getting entangled in the camera, fasten the Safety wire to
the bracket with Cable Tie. (FIG.8)
(M4 x 16 - 4EA)
CONTENTS
1EA 5. SCREW M4 x 16
4EA 6. SPRING WAHGER Ø4
4EA 7. WRENCH (3mm)
4EA 8. MANUAL
010
Installation
ZT-PTS SERIES
B-4. Install 4 pieces of Anchor bolt in the Ø13 holes at the edge and connect the
cables.
5EA
5EA
1EA
B-5. Adjust the Camera and Pole Stand to M10 x 45 Bolt and Flat Washer, Spring
Washer. And then tight enough with Nuts. (FIG.10)
ZT-PTS SERIES
(M10 x 45 - 4EA)
011