Table of Contents
Advertisement
B-5. Adjust the Camera and Pole Stand to M10 x 45 Bolt and Flat Washer, Spring Washer. And
then tight enough with Nuts. (FIG.10)
Installation
C. Wall Mount Bracket
1. WALL MOUNT BRACKET 1EA
2. SET ANCHOR BOLT (W5/6) 4EA
3. SCREW M4 x 16 5EA
C-1. When you install IR PTZ Camera on the wall, make 4 holes at the edge with Ø13 in diameter
and 37mm in depth and install 4 pieces of Anchor bolt in the Ø13 holes at the edge. (FIG.11)
• If you want to connect the cables from the inside of the wall, also make a hole for the cables
with about Ø30~50 in diameter in the center of 4 edges.
• In order to avoid the impact of the Camera and Bracket when moving, set and drill in the long
side as length and the short side as height.
• Check also if the long side of the Bracket sets as length and the short side of the Bracket sets
COMPONENTS
4. SPRING WASHER Ø4 5EA
5. WRENCH (3mm) 1EA
6. MANUAL
Advertisement
Table of Contents
