Table of Contents
Advertisement
A-5. Install 4 pieces of Anchor bolt in the holes at the edge and tight enough with Nuts. (FIG.4)
A-6. Connect the cables referring to the page 8. (FIG.5)
Installation
B. Pole Stand
1. POLE STAND 1EA
2. BOLT M10 x 45 4EA
3. NUT M10 4EA
4. FLAT WASHER 4EA
5. SPRING WASHER Ø10 4EA
B-1. When you install IR-PTZ Camera on the pole, make 4 holes at edge with Ø13 in diameter and
37mm in depth. Make also a hole for the cables with about Ø30~50 in diameter in the
bottom center of the bracket. (FIG.6)
COMPONENTS
6. SCREW M4 x 16 5EA
7. SPRING WAHGER Ø4 5EA
8. WRENCH (3mm) 1EA
9. MANUAL
Advertisement
Table of Contents
