Installation Modes; Ceiling Mount Installation - Ganz ZN8 User Manual

IR Vandal Dome Network Camera
User Manual
Tool
Video cables (delivered with the camera)
JY-F plug wrench (delivered with the
camera)
Swell plastic buttons (delivered with the
camera)
To avoid moisture influence, install the dome cover at least half an hour after the
camera is installed and powered on.

3.2 Installation Modes

You can install the IR vandal dome camera in the ceiling mount, wall mount, wall side
mount bracket, or ceiling bracket installation mode depending on the actual installation
scenario. This section describes how to install the camera in the ceiling and wall mount
modes.

Do not detach the protective film from the dome cover before all the installation steps are
complete.

Keep the dome cover clean during the installation. Do not contact the dome by hand or
with other materials to avoid affecting video image quality.

3.2.1 Ceiling Mount Installation

The ceiling mount installation mode can be subdivided into installation by the white
lower cover and direct installation by the main body black base cover. The ceiling
mount installation mode applies to indoor ceilings or eaves, as shown in Figure 3-1.
Issue V1.3 (2016-02-22)
Appearance
3 Device Installation
7