Radio Settings - Siemens SCALANCE W780 Configuration Manual

Configuring with Web Based Management
5.3 "Wizard" menu
5.3.1.6

Radio Settings

Introduction
On this Basic Wizard page, you specify the configuration for the WLAN interfaces.
Description
This table contains the following columns:
● Radio
Shows the available WLAN interfaces.
● Enabled
Enable or disable the WLAN interface. The WLAN interfaces are disabled when the
device is supplied.
● Radio Mode
Shows the mode of the WLAN interface.
● Frequency Band
Specify the frequency band. In client mode, dual-frequency operation is also possible.
Note
Configuring WLAN interfaces of the W786-2IA RJ-45 for different frequency bands
If both WLAN interfaces are configured for the same frequency band on this device, there
may be mutual influence or interference. This applies in particular when there is a high
data throughput.
● WLAN Mode
Select the required transmission standard for the configured frequency band.
– WLAN Mode 2.4 GHz
– WLAN Mode 5 GHz
72
Specify the transmission standard for the 2.4 GHz frequency band. The selection
depends on the country setting.
Specify the transmission standard for the 5 GHz frequency band. The selection
depends on the country setting.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08