Siemens SCALANCE W780 Configuration Manual page 310

Appendix D
D.1 Messages in the event log
Status of the WLAN interface (in access point mode only)
Messages
Link down up VAP X.Y.
Link down on VAP X.Y.
WDS Y at WLAN X is up.
WDS Y at WLAN X is down.
Overlap-AP found on WLAN X: AP <system name> <MAC>
found on channel <channel number.> <RSSI value>
Overlap-AP aged out on WLAN X: AP <system name>
<MAC> on channel <channel number.> <RSSI value>
DFS: Radar interference detected on WLAN X at channel
<channel number> (frequency <frequency> MHz). Changing
to channel <channel number> (frequency <frequency> MHz)
DFS: channel <channel number> (frequency <frequency>
MHz) aged out from NOL at WLAN X and can be used
again.
DFS: Radar interference detected on WLAN X at channel
<channel number> (frequency <frequency> MHz). No more
free channels to use!!
Status of the WLAN interface (in client mode only)
Messages
Link up on WLAN X.
Link down on WLAN X.
Messages on configuration
Messages
WBM: Authentication failure.
Telnet: Authentication failure.
Restart requested
310
Description
When logging in with Web Based Management (WBM), the wrong password was en-
tered. The event can be enabled or disabled in "System -> Events" (authentication fail-
ure).
When logging in via Telnet, the wrong password was entered. The event can be enabled
or disabled in "System -> Events" (authentication failure).
Restart due to a user request. The event can be enabled or disabled in "System ->
Events" (cold/warm start).
The VAP interface Y on the WLAN interface X is enabled.
The VAP interface Y on the WLAN interface X is disabled.
A link exists on the WDS interface Y of WLAN interface X.
No link exists on the WDS interface Y of WLAN interface X.
A further access point was detected on the channel set for
the WLAN interface X or on a neighboring channel.
The overlapping access point could not be detected during
the configured aging time and was removed from the "Over-
lap AP" list.
A primary user (e.g. radar or weather station) was detected
on the channel set for WLAN interface X or on a neighboring
channel. The channel will be blocked for 30 min. The access
point changes to the configured alternative channel or to the
next free channel on which there is no primary user.
No primary user detected on the channel any longer. The
channel was removed from the list of blocked channels and
can be used again
A primary user was found on all available channels. There is
no free channel available, the WLAN interface X will be
deactivated until one of the channels becomes available.
Description
The WLAN interface X is enabled.
The WLAN interface X is disabled.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08