Siemens SCALANCE W780 Configuration Manual page 246

Configuring with Web Based Management
5.7 "Layer 2" menu
Description
The page contains the following boxes:
● "Base Bridge Mode" drop-down list
Specify whether or not the device is configured as a bridge according to IEEE 802.1D for
the Spanning Tree protocol or according to IEEE 802.1Q for a virtual bridged LAN:
– 802.1 D Transparent Bridge
– 802.1 Q VLAN Bridge
● Input box "VLAN ID"
Enter the VLAN ID in the "VLAN ID" input box.
Range of values: 1 ... 4094
The table has the following columns:
● Select
Select the check box in the row to be deleted.
● VLAN ID
Shows the VLAN ID. The VLAN ID (a number between 1 and 4094) can only be assigned
once when creating a new data record and can then no longer be changed. To make a
change, the entire data record must be deleted and created again. Up to 24 VLANs can
be defined.
● Name
Enter a name for the VLAN. The name only provides information and has no effect on the
configuration. The length is a maximum of 32 characters.
● Status
Shows the status type of the entry in the internal port filter table. Here, static means that
the address was entered as a static address by the user.
● List of ports
Specify the use of the port. The following options are available:
– "-"
– M
– U (uppercase)
– u (lowercase)
– F
246
Sets the mode of the device to "transparent" for the Spanning Tree protocol.
Sets the mode of the device to "VLAN-aware" for a virtual bridged LAN. Configure the
port-based VLAN
The port is not a member of the VLAN.
With a new definition, all ports have the identifier "-".
The port is a member of the VLAN. Frames sent in this VLAN are forwarded with the
corresponding VLAN tag.
The port is an untagged member of the VLAN. Frames sent in this VLAN are
forwarded without the VLAN tag. Frames without a VLAN tag are sent from this port.
The port is an untagged member of the VLAN, but the VLAN is not configured as a
port VLAN. Frames sent in this VLAN are forwarded without the VLAN tag.
The port is not a member of the specified VLAN. You can configure other settings in
"Layer 2 > VLAN > Port-based VLAN".
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08