Available Ap - Siemens SCALANCE W780 Configuration Manual

Configuring with Web Based Management
5.4 "Information" menu
5.4.11.6

Available AP

Available access points
Note
This page is only available for clients or access points in client mode.
This page shows all the access points visible to the client. The list also includes the access
points to which the client cannot connect due to its configuration.
Note
Display when iPCF mode is activated
If the iPCF mode is active with a SCALANCE W700, the display is different. Since the client
does not run a background scan in this case, only the access point with which the client is
currently connected is displayed.
Description
The table has the following columns:
● Radio
Shows the WLAN interface visible to the access point.
● SSID
Shows the SSID of the access point.
● BSSID
Shows the MAC address of the access point.
● System Name
all access points support this parameter.
● Channel
Shows the channel on which the access point transmits or communicates.
● Signal Strength [dBm]
Shows the signal strength of the access point in dBm.
● Signal Strength [%]
Shows the signal strength of the access point as a percentage.
● Type
Shows the mode of the WLAN interface.
120
displays the system name of access point. The entry depends on the access point. Not
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08