Start-Up On Power Unit - Lincoln Electric SUBARC 5 Instructions For Use And Maintenance Manual

E - OPERATOR MANUEL

4 - START-UP ON POWER UNIT

Switch on the installation.
Check the direction of rotation of the wire feed motor.
In order to reverse the direction of rotation :
Interchange the motor wires
Interchange the wires of the tacho generator.(on SUBARC 5)
Adjustment of U and I display units :
- Switch off the installation.
- Then switch on again keeping the stop push-button pressed in and by turning the flux switch to
the flux stop position (to the right)
- After switching on: release the buttons
- No button is to be touched during the following adjustment.
- Open the console and adjust:
- The display unit of I to 1500 A
- The display unit of U to 100,0V
After the adjustment, press the wire feed button then the raising button, the values on the
display units change.
Selection of the generator :
- The wire raising button allows you to increment.
- The wire feed button allows you to decrement.
- The ON button makes it possible to validate the choice of the generator.
- The display unit of A indicates the generator selection (table below)
- When the generator is selected the display unit of V indicates 100 V.
100
I DISPLAY UNIT
650
POWER SOURCE
STARMATIC
DC
Switch on the installation.
E-38
200 300 400 500
1000 1300
DC DC
600 700 800 900
800 600
TH TH
1000 1100 1200
1003
1003 1003 1303
AC/DC
DC DC
SUBARC 5 - DX7
8695 5240 / M
1300 1400 1500
2X
DC
en
//