8695 5240 / M
In the power unit:
- Remove the cover of the power unit by unscrewing the 4 screws item A11.
- Insert into the power unit through the grommet item A9
all the cables coming from the welding head (except welding cables)
the supply cable delivered with the installation (If more length is required, use a
3x2,5 mm² cable)
the control harness previously connected to the power source
- Anchor these cables by inserting them between the metallic rods item A10
CYCLE BOARD SIDE item C6:
- Connect the console cable to J6, J9 and J10 of the cycle board.
- Connect the cable for arc voltage measurement to J11 of the cycle board.
- Connect the control cable of the power source to J15 of the cycle board.
(for a STARMATIC 800AC)
- Connect the wires of the tacho generator to connector J1 (item: 8 and 9) shield rep10
of the variable speed unit C7.
- Connect the control cable of the power source to J2 of the cycle board.
TRANSFORMER SIDE:
- Connect the wires of the cable of the wire feed motor to terminals 20 and 21.
- Fit solenoid valve F18
- Connect the wires of the solenoid valve cable to the fuse holders F7 and to terminal 16.
- With valve option for recycling, connect the wires of the recycling solenoid valve cable
to fuse holder FU8 and to terminal 16.
- Connect the feed wires to terminals L1-L2 and the green/yellow wire to the
equipotential connecting copper rod
- Connect the feed wires to terminals L3-L4 and the green/yellow wire to the
equipotential connecting copper rod
- Adjust coupling of transformers TR1 and TR2 according to the mains voltage.
SUBARC 5 - DX7
D - ASSEMBLY CONNECTION
D-25