Preparations Before Welding On Control Unit (Mig); Welding (Mig) Version Subarc 5; Mig Welding, Version D2C Saw - Lincoln Electric SUBARC 5 Instructions For Use And Maintenance Manual

8695 5240 / M

10 - PREPARATIONS BEFORE WELDING ON CONTROL UNIT (MIG)

MANUAL CONTROLS
wire feed up
wire feed down
hight wire feed speed.
gas test
PREPARATION
Make sure that the gas supply is adjusted and in operation

11 - WELDING (MIG) VERSION SUBARC 5

Press P6 and keep it pressed in (if you do not want to use the pre-gas C19)
flows
Release P66
Before welding start the flux flows for the duration of the timeout (adjustment by C 19). Once
welding is established, improve the adjustments of US and IS with potentiometers P1 and P5
Press P7 to stop welding
INFORMATION
Storing the welding parameters
SAW only
It is possible to store the welding parameters by pressing P6 during welding
After welding stops, the parameters taken into account during the pulse are restituted on the
display units

12 - MIG WELDING, VERSION D2C SAW

SUBARC 5 - DX7
NB: for the controls of D2C SAW, refer to the
instructions: 8695 6051
Refer to the instructions for D2C SAW: 8695 6051
E - OPERATOR MANUEL

the flux
E-43