Chapter 2 Install Your Product; Plug In Signals; Plug In Main Power; Turn On Your Product - RGBlink X3p User Manual

Chapter 2 Install Your Product

2.1 Plug in Signals

Connect signals to the product (ensure all the device are all power off first).Tighten
connector screws/locks where provided.

2.2 Plug in Main Power

Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.

2.3 Turn on Your Product

Turn on the power switch on the real panel.
OLED display will show as below,completing initialization before loading the latest settings
and input/output configuration.
The system begins to work,and the OLED module shows the input slot and output slot
information, device status, COM. Versions. IP address and serial number.

2.4 Connect X3p and Computer

Use network cable to connect the X3p and computer as the following picture show:
X3p User Manual
11