Connecting The Power Cord - H3C SecPath PSR300-12A2 User Manual

Connecting the power cord

Connecting the AC power cord
WARNING!
•
Make sure each power cord has a separate circuit breaker.
•
Before connecting a power cord, turn off the circuit breaker
for it.
To connect the AC power cord:
1. As shown in
connector of the AC power cord into the AC-input power
receptacle on the power module, and then pivot down the bail
clasp.
Figure 5 Connecting the AC power cord to the power module
2. Connect the other end of the AC power cord into an AC power
source, and turn on the circuit breaker for the power cord.
3. Turn on the power switch on the power module. If the AC OK
LED is on, the power cord is connected correctly. If the AC OK
LED is off, the connection might be wrong. Verify the installation
and resolve the problem.
Figure 5, pivot up the bail clasp, insert the female
8