Field Of Application - WAGNER POWERPAINTER 90 EXTRA Translation Of The Original Operating Instructions

PowerPainter 90 EXTRA
15 Inlet filter
17 Holder for paint container
19 Operating instructions
* filter pre-installed in gun
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
The following coatings can only be used together with optional accessories (nozzle and filter)
i
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC
lacquers, undercoats, base coats, fillers and anti-rust paints.
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and acidic coating substances.
Flammable materials
In order to ensure compatibility of the coating substance with the materials used to manufacture the device, please
i
contact Wagner Service in cases of doubt.

Field of application

Coating interior walls and outside objects (e.g. garden fences, garage doors, etc.).
Required tools and auxiliary material
•
Adjustable wrench (2 pcs.)
•
Crosshead screwdriver
•
Empty container
•
A large piece of cardboard
•
Covering material
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a consequence of sprayed material entering the
socket!
Mask all the areas and objects that are not to be spray painted, or remove them from the work area.
No liability is assumed for damage due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All such surfaces must therefore be completely
Danger
covered.
Pay attention to the quality of the adhesive tape used. Do not use excessively strong adhesive tape on wallpaper and
i
painted surfaces, in order to avoid damaging these surfaces when removing the tape. Remove adhesive tape slowly
and evenly; do not use jerky movements. Do not leave adhesive tape on surfaces any longer than necessary, in order to
minimise the possibility of residues when removing. Also observe the adhesive tape manufacturer's instructions.
Preparation of the Coating Material
Using PowerPainter 90 interior wall paints, varnishes and glazes can be applied by spraying without diluting them, or by diluting
them slightly. Detailed information is available in the technical data sheet of the manufacturer ( Internet download).
1. Stir the material thoroughly and dilute it in the container as per the recommended dilution (an agitator is recommended for
stirring).
Sprayed material
Glazes
Wood preservatives containing solvents or based on water, mordants, oils, disinfection agents, plant
protective agents
Paints containing solvents and watersoluble paints, primers, vehicle coating paints, thick-film glazes
Interior wall paint (dispersions and latex paint)
Description (Fig. 1)
16 Suction hose
18 Oil
20 Pressure gauge
Thinning recommendation
GB
undiluted
undiluted
dilute by 5 - 10 %
dilute by 0-10 %
21