Table of Contents
Advertisement
W 600 Flexio 18V
•
Never service damaged batteries. All maintenance of batteries should only be carried
out by the manufacturer or authorised service centres.
•
Protect the battery from heat, e.g. also from permanent sunlight, fire, dirt, water
and moisture. There is a risk of explosion and short circuit.
•
Operate and store the battery only at an ambient temperature between -20°C and
+50°C. Do not leave the battery in the car in summer, for example. At temperatures <
0°C, performance may be restricted depending on the unit.
•
Charge the battery only at ambient temperatures between 0°C and +35°C. Charging
outside the temperature range can damage the battery or increase the risk of fire.
•
Lithium-ion batteries are subject to the Dangerous Goods Legislation requirements.
The batteries are suitable for road-transport by the user without further restrictions.
When shipping by third parties (e.g.: by air transport or forwarding agency), special
requirements on packaging and labelling must be observed. For preparation of the item
being shipped, consulting an expert for hazardous material is required. Dispatch battery
packs only when the housing is undamaged. Tape or mask off open contacts and pack
up the battery in such a manner that it cannot move around in the packaging. Please
also observe the possibility of more detailed national regulations.
5. Description/ Scope of delivery
1) Nozzle
3) Union nut
5) Wall Extra I-Spray spray attachment
7) Air volume control
9) Air filter cover
11) Trigger
13) Battery lock*
15) Valve
17) Stirring rod
19) Practice poster
21) Charger*
23) Lubricating grease**
* Not included in the delivery. A starter kit with charger and rechargeable battery is
available with order No. 2448616 (EU) and 2448617 (UK).
** This is inside the container: remove it before starting operations!
6. Field of application
Many different coating substances can be processed with the W 600.
Depending on the coating material, a different spray attachment and power level must
be used:
Description/ Scope of delivery (Fig. 1)
2) Air cap (to set the working direction)
4) Spray jet width adjustment
6) Material volume adjustment
8) Battery indicator
10) ON/OFF switch (located on both sides)
12) Rechargeable battery*
14) Container
16) Ventilating hose
18) Feed hopper (2 pcs.)
20) Standard spray attachment
22) Replacement nozzle seal (Standard
spray attachment)**
EN
15
Advertisement
Table of Contents
