Control The Led; Diagnostic - TP-Link Archer C20 User Manual

Chapter 4
5. Enter the
6. Click Save.
¾ To set time automatically:
7. Select your local
8. Enter the address or domain of the
9. Click
¾ To set Daylight Saving Time:
1. Select
2. Select the start time from the drop-down list in the
3. Select the end time from the drop-down list in the
4. Click Save.
Note:
This setting will be used for some time-based functions such as firewall. You must specify your time zone once you log
in to the router successfully; otherwise, time-based functions will not take effect.

4. 15. 2. Control the LED

The router's LEDs indicate router's activities and status. You can turn on or turn off the
LEDs from the web management page.
To turn off LEDs during Night Mode Period:
1 ) Visit http://tplinkwifi.net, and log in with the username and password you set for
2 ) Go to
3 ) Check the box for
4 ) Specify a time period in the
5 ) Click Save.

4. 15. 3. Diagnostic

Diagnostic is used to test the connectivity between the router and the host or other
network devices.
Downloaded from www.Manualslib.com
Time in Hour/Minute/Second format.
time zone.
Get GMT to get time from the Internet if you have connected to the Internet.
Enable DaylightSaving.
the router.
System Tools > LED
Enable Night
during this period.
manuals search engine
NTP Server I or NTP Server
Start field.
End field.
Control.
Mode.
LED Off Time as needed, and the LED will be off
II.
63