TP-Link Archer C2600 Quick Installation Manual

Quick Installation Guide
AC2600 Wireless Dual Band Gigabit Router
7106505351 REV1.0.0

Connect the Hardware

If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router's Internet port, then follow steps 5 and 6 to
complete the hardware connection.
Internet
Power adapter
Archer C2600
2
Turn off the modem,
and remove the backup
battery if it has one.
Modem
3
Connect the modem to the
Internet port on your router
with an Ethernet cable.
4
Turn on the modem, and then
wait about 2 minutes for it to
restart.
1
Install the antennas.
6
Verify that the following LEDs are
on and solid before continuing
with the configuration.
Power 2.4G 5G Internet
On On
On On
Note: If the 2.4G LED and 5G LED are off, please
press the Wi-Fi On/Off button on the side panel for 2
seconds and check the LEDs again a few seconds later.
Power adapter
5
Turn on the router.
30° 30°
For optimum performance,
orient the four antennas as
shown in the drawing
beside.