Nakanishi E3000 SELECTOR Operation Manual page 6

CAUTION
⑤ When an errors occurs, and Error LED will illuminate on the SELECTOR, an Error Code will be
displayed on the CONTROLLER and cause an Error Code output to be sent, stopping the Motor.
Check and correct the cause of the malfunction before continuing use. Failure to correct the
problem will result in damage to the CONTROLLER and motor spindle.
⑥ When the warning LED on the SELECTOR blinks, conditions exist that could result in dangerous
operation. Check operating conditions and continue to use only after correcting the problem.
⑦ When using CONTROLLER continuously, refer to continuous area on torque Characteristics Graph
and check LOAD Monitor LED of the CONTROLLER for a maximum output of (3 Green LED's).
⑧ Do not install the system next to RF noise sources, as malfunctions can occur.
⑨ If smoke, noise or strange odors emanate from the SELECTOR, CONTROLLER or motor,
immediately turn OFF the Main Power Switch.
⑩ Do not place anything on top of the SELECTOR.
⑪ Attach the provided connector cap (for motor output) and air plug (for air stoppage) for safety
and dust proo¿ng when not using SELECTOR.
⑫ Connect to the E3000 CONTROLLER when using E3000 SELECTOR.
⑬ When disposal of CONTROLLER or SELECTOR is necessary, follow the instructions from each
local government and dispose as an industrial waste.
⑭ Stop working immediately when abnormal rotation or unusual vibration are observed. Please
check the content of P57 " 15. TROUBLESHOOTING " section.
33