Nakanishi E3000 SELECTOR Operation Manual page 14

9 - 2 Installation of the Rubber Pad
Caution when installing the SELECTOR horizontally
・ When rotating the direction of Control Panel ② , ensure that the Main Power Switch ⑭ is turned
OFF and the Power Cord has been removed from the SELECTOR.
・ Never the install the SELECTOR with the Control Panel ② upward. This may allow debris to
enter the SELECTOR causing electric shock or ¿ re.
When placing the SELECTOR horizontally, the Rubber Pads (Provided) must be installed on the side of the
SELECTOR.
The Control Panel ② can be rotated 90ﾟfrom the original position. To rotate, remove the 4 Control Panel Mounting
Screws attached to Control Panel ② . Change position of the Control panel ② and re-install the 4 Control Panel
Mounting Screws.
9 - 3 Proper Clearance
CAUTION
When installing 2 or more CONTROLLER's in the machine cabinet, make sure to check that each
unit has the proper clearance on all sides for suf¿ cient air À ow.
Insuf¿ cient clearance will cause heat damage to the CONTROLLER and SELECTOR.
When installing the CONTROLLER and SELECTOR, refer to Fig. 10 and Fig. 11.
min.30mm
Fig. 10 Vertical Mounting
Rubber Pad
Fig. 8
min.20mm
Control Pnel
Mounting Screw
Control Pnel ②
Fig. 9
min.30mm
Fig. 11 Horizontal Mounting
min.20mm
41