Control Panel Features - Nakanishi E3000 SELECTOR Operation Manual

7 . CONTROL PANEL FEATURES

7 - 1 System
① E3000 SELECTOR
② Control Panel
Refer to P39 " 7 - 2 Control Panel Details " section.
③⑤⑦⑨ Motor Output Connector
Connects the Motor Cord Plug to the SELECTOR. Attach the provided Connector Caps (for Motor output) for
safety and dust proo¿ ng when not using other Motor Output Connector.
④⑥⑧⑩ Air Output Joint
Supply clean, dry, regulated air for motor and spindle cooling and purging. Attach the provided Air Plugs ( 4)
for air stoppage) for safety and dust proo¿ ng, when not using other air output joints.
⑪ Motor Input Connector
Connects the Motor Communication Cord (length : 60cm) from the E3000 CONTROLLER Motor Connector to
the SELECTOR Motor Input Connector.
⑫ Air Input Joint
Supply clean, dry, regulated air for motor cooling. Regulate air pressure to 0.35MPa (50.8psi). Max. Air
Consumption 120Nℓ/ min. Air must be supplied to operate the system correctly.
CAUTION
If the air pressure is too low the E3000 CONTROLLER and SELECTOR will not operate.
⑬ Serial I/F Connector
Connect the provided Communication Cable to the E3000 CONTROLLER Serial I /F Connector to the E3000
SELECTOR Serial I/F Connector. Attach the provided Serial I /F Connector Cover for safety and dust proo¿ ng,
when not using E3000 SELECTOR.
⑭ Main Power Switch
ON / OFF main power source. The designation " I " Indicates ON. The designation " O " Indicates OFF.
⑮ Main Power Inlet with Power Supply Fuses
Insert the Power Cord Plug. Refer to P42 " 10. POWER CORD CONNECTION " section.
Two fuses (T1.6AL (250V)) have been installed. Make sure the proper rated and type of fuses when
replacements are necessary.
When replacing fuses, refer to P40 " 8. REPLACING THE FUSES " section.
38
⑪
⑫
⑬
⑭
⑮
Fig. 3
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩