Nakanishi E3000 SELECTOR Operation Manual page 12

7 - 2 Control Panel Details
⑯ Error LED (ERROR)
When a problem with the E3000 SELECTOR, or motor alarms are detected, this LED illuminates. The motor
may shut down and the Digital Speed Indicator in E3000 CONTROLLER Control Panel will display an error
code.
⑰ Warning LED (WARNING)
The operating and working conditions of the E3000 SELECTOR and motor are constantly monitored and the
Warning LED À ashes when a hazardous condition has been detected. When a hazardous condition is detected
the Warning LED À ashes and the Digital Speed Indicator on E3000 CONTROLLER Control Panel alternates
between the warning code and the actual or preset speed, depending on whether or not the motor spindle is
rotating or not.
⑱ Rotating LED (RUN)
When the motor is rotating this LED will illuminate.
⑲ LINK LED (LINK)
LINK LED illuminates when E3000 SELECTOR is correctly connected to E3000 CONTROLLER.
Con¿ rm that the LINK LED lights after connecting the provided Communication Cable.
⑳ Selection motor LED
The LED corresponds to the selected motor port.
㉑ Motor Speed Adjustment Button (SPEED
Manual adjustable speed control is possible. (
㉒ Rotation Direction Button (DIR)
Right hand rotation (FWD.) and left hand rotation (REV.) are as viewed with the cutting tool facing the operator.
With the cutting tool facing the operator right hand rotation (FWD.) will be clockwise rotation.
㉓ Motor Selection Button (MOTOR)
Select the motor to be controlled, either motor (No.1 / No.2 / No.3 / No.4 motor.)
If motor No.1 selected, LED ⑳ (Motor -1) illuminates.
㉔ Motor Rotation Direction LED
LED illuminates Green indicates Right hand rotation (FWD.).
LED illuminates Orange indicates Left hand rotation (REV.).
㉕ Digital Speed Indicator
Preset speed, actual speed are displayed in 2 digit format.
⑯ ⑰ ⑱ ⑲ ⑳
㉔
㉕
Fig. 4
, )
(UP) or
㉑
㉒
㉓
(DOWN)) (1 digit is 1,000min
-1
(rpm).)
39