Nakanishi E3000 SELECTOR Operation Manual page 4

Ampere Rating
More Than Not More Than
0 6
6 10
10 12
12 16
Only the applicable parts of the Table need to be included. For instance, a 120-volt product need include the
240-volt heading.
B. OTHER WARNING INSTRUCTIONS
1. For your own safety read instruction manual before operating this tool.
2. Replace cracked collet or collet nut immediately.
3. Do not over tighten the collet nut.
4. Use only NAKANISHI manufactured collets and arbors for grinding and sawing applications.
5. REMOVE ADJUSTING KEYS AND WRENCHES. Always check to see that keys and adjusting
wrenches are removed from tool before turning the units main power switch on.
6. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
7. DO NOT USE IN DANGEROUS ENVIRONMENTS. Don't use power tools in damp or wet locations, or
expose them to rain.
8. Keep work area well illuminated.
9. There is a risk of injury due to accidental starting. Do not use in an area where children may be
present.
10. DO NOT FORCE THE TOOL. Never use a tool for an application it was not designed for.
11. USE THE CORRECT TOOL. Do not force tools or attachments to do a job for which it was not
designed.
12. WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neck ties, rings, bracelets, or other
jewelry that might get caught in moving parts. Nonslip footwear is recommended. Wear protective
hair covering to contain long hair.
13. ALWAYS USE SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they are
NOT safety glasses. Also use face or dust mask if cutting operation is dusty.
14. SECURE YOUR WORK. Use clamps or a vise to hold work at all times.
15. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best performance and to reduce the
risk of injury. Follow instructions for changing accessories.
16. DISCONNECT TOOLS before servicing or when changing accessories, such as blades, cutters etc.
17. REDUCE THE RISK OR UNINTENTIONAL STARTING. Make sure Main Power Switch is in off
position before plugging in.
18. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don't leave tool until it comes
to a complete stop.
19. For recommended operating speed for various applications, please follow recommendations of the
cutting tool manufacturer.
Minimum gage for cord
Volts
120V 7.5m (25ft.)
240V 15m (50ft.)
18
18
16
14
Total length of cord
15m (50ft.) 30m (100ft.)
30m (100ft.) 60m (200ft.)
16 16
16 14
16 14
12 Not Recommended
45m (150ft.)
90m (300ft.)
14
12
12
31