Power Cord Connection - Nakanishi E3000 SELECTOR Operation Manual

10 . POWER CORD CONNECTION

WARNING
Only use grounded power sources. Failure to properly ground the SELECTOR may result in
electric shock, injury, ¿ re and / or damage to the system components.
CAUTION
・ When connecting the Power Cord Plug, make sure the Main Power Switch ⑭ is turned OFF.
・ When installing the SELECTOR, provide space of approximately 10cm around the SELECTOR
for easy access to the air inlet and the Power Cord Plug.
(1) Insert the female Power Cord Plug into the Main Power Inlet with Power Supply Fuses ⑮ on the front of the
SELECTOR.
(2) A tapped hole is provided on the lower, right side of the SELECTOR for attaching the tension relief. Use the
provided nylon tension relief to attach the Power Cord to the side of the SELECTOR when mounting vertically.
* When placing the SELECTOR horizontally (Fig. 12), do not use the provided nylon tension relief to attach the
Power Cord to the side of the SELECTOR.
11 . MOTOR CORD CONNECTION
CAUTION
Before connecting to the Motor Cord Plug, make sure the Main Power Switch ⑭ is turned OFF.
If the Main Power Switch ⑭ is turned ON while connecting the Motor Cord Plug, damage may
occur to the SELECTOR.
(1) Ensure the alignment pin is located upward (12 o'clock position).
(2) Carefully insert the Alignment Pin into the Alignment Hole and push straight into the Motor Output Connector
on the front of the SELECTOR.
(3) Tighten the Connector Nut.
Alignment Pin
42
⑮ Main Power Inlet with
Power Supply Fuses
Nylon Tension Relief
Connector Nut
Fig. 13
Fig. 12
Alignment Hole
Fig. 14