Connection Of The E 3000 Controller To The Selector - Nakanishi E3000 SELECTOR Operation Manual

12 . CONNECTION OF THE E 3000 CONTROLLER TO THE SELECTOR

12 - 1 Connection of the Motor Communication Cord to the SELECTOR
Connect the provided Motor Communication Cord (length : 60 cm) from the SELECTOR to Motor Connector on
the E3000 CONTROLLER.
Motor Input Connector ⑪ refer to P42 " 11. MOTOR CORD CONNECTION " section.
CONTROLLER
Motor Connector
12 - 2 Connection of Communication Cable
CAUTION
Never use the provided Communication Cable for any purpose other than connection between
the CONTROLLER and SELECTOR. Do not use any cable other than the provided Communication
Cable for data transfer between the CONTROLLER and SELECTOR. Failure to adhere to this
caution could cause damage to the CONTROLLER and SELECTOR.
Connect provided Communication Cable (length : 60 cm) to Serial I / F Connector on the E3000 CONTROLLER
and Serial I / F Connector ⑬ on the E3000 SELECTOR. After connecting, be sure to tighten the mounting screws
of the Communication Cable (length : 60cm).
CONTROLLER
Serial I / F Connector
Communication Cable
(Length : 60cm. Provided)
SELECTOR
⑪
Motor Communication Cord
Fig. 15
Fig. 16
Motor Input Connector
(length : 60cm)
SELECTOR
⑬ Serial I / F Connector
43