Important Instructions And Warning - Electric Devices - Nakanishi E3000 SELECTOR Operation Manual

IMPORTANT INSTRUCTIONS AND WARNING - Electric Devices

WARNING
When using electric tools, basic safety precautions should always be followed to reduce the risk of ¿re, electrical
shock and personal injury.
Read all these instructions before operating this product and save these instructions.
A. GROUNDING INSTRUCTIONS
1. In the event of a malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This tool is equipped with an electric cord with
a grounding conductor and a grounding plug. The plug must be plugged into a matching outlet
that is properly installed and grounded in accordance with all local codes and ordinances.
2. Do not modify the plug provided if it dose not ¿t the outlet, A quali¿ed electrician must install the
proper outlet.
3. Improper connection of the grounding conductor can result in electric shock. The conductor with
insulation having an outer surface that is green with or without yellow stripes is the grounding
conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the
grounding conductor to a live terminal.
4. Check with a quali¿ed electrician or service person if the grounding instructions are not completely
understood, or if in doubt as to whether the tool is properly grounded.
5. Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole receptacles that
accept the power cords plug.
6. Repair or replace damaged or worn cord immediately.
7. This tool must be used on a circuit that has an outlet that looks like the one illustrated in Sketch
A in ¿gure (See below) (115V). The tool has a grounding plug that looks like the plug illustrated in
Sketch A in Figure (below).
8. FOR Installation in Machine Electrical Cabinet or when
wiring directly to machine internal power terminal strip:
1) Please refer to the pin diagram below for the proper
wiring con¿guration. The plug shown is the female
plug that attaches to the E3000 SELECTOR main power
inlet.
2) Make sure you test each individual wire to verify proper
circuit prior to attaching any wire to the terminal block.
Do not assume wire colors are the same for all power
cords.
9. Install an over current protective device of maximum 10
Amps on the E3000 SELECTOR main power circuit.
10. USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry
the current your product will draw.
An undersized cord will cause a drop the line voltage
resulting in loss of power and overheating.
Table (below) shows the correct size to use depending on
cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the
gage number, the heavier the cord.
30
Grounding Method
A
Power cord connector
L : Line
N : Neutral
E : Earth
L E N