Nakanishi E3000 SELECTOR Operation Manual page 24

Pin
Code Function
No.
6 RUN Rotating
Rotating
7 DIR_OUT
Direction
8 ERR Error
― Not used
9
Internal GND
for Motor
10 GND
Speed Control
Voltage
Internal Power
Source for
11 Vcc Motor Speed
Control
Voltage
Motor Current
12 MOTOR_I
Monitor
Internal GND
13 GND for Analog
Monitor
Rotate
14 START
Command
UP / DOWN
Signal for
15 UD_IN
Setting Motor
Speed
Rotates Motor
-1
500min
16 at "Centering"
(rpm)
speed
Input /
Output
' OFF (Open) ' :
Stop
Output
' ON (Closed) ' :
Rotating
' OFF (Open) ' : FWD.
Output
' ON (Closed) ' : REV.
' OFF (Open) ' :
Error
Output
' ON (Closed) ' :
Normal
― ―
Internal
Output CONTROLLER
GND
Internal Power
Output
Source : DC+10V
2Amp / V,
Output
0V ≦ MOTOR_I ≦ 10V
Internal
Output CONTROLLER
GND
' OFF (Open) ' :
Stop
Input
' ON (Closed) ' :
Start
' OFF (Open) ' :
Speed Down
Input
' ON (Closed) ' :
Speed Up
' ON (Closed) ' :
-1
500min (rpm)
Input
' OFF (Open) ' :
Normal Operation
Description
Output shows that the motor is rotating.
Output shows the direction of the Motor is
rotating.
Output shows that error has occurred. Error
code will be displayed on Digital Speed
Indicator of the E3000 CONTROLLER.
When setting parameter
Mode can be changed. (Refer to P84 "18 - 3 ①
Setting of Error Output Mode" section of
the E3000 CONTROLLER Operation Manual.)
*Note : Never use pin labeled not used.
This GND will be used for "Motor Speed
Control Voltage (VR)".
Internal Power Source for "Motor Speed
Control Voltage (VR)".
Output Motor Current Monitor with Analog
Monitor Voltage.
2Amp / 1V. Max. 20Amp.
This GND will be used for analog monitor
(MOTOR_I, SPEED_V, and LOAD).
Motor Start and Motor Stop Signal
Setting parameter , can start with
forward rotation. (Refer to P86 "18 - 3 ⑥
Selection of External Motor Start
Signal Control Mode" section of the E3000
CONTROLLER Operation Manual.)
Determines speed up or speed down.
Need to set parameter
P85 "18 - 3 ⑤ Selection of External
Speed Control Mode" section of the E3000
CONTROLLER Operation Manual.)
Set motor rotation speed is 500 min
Use the Centering Mode.
, Error Output
. (Refer to
-1
(rpm).
51